HIGH SPEED DIRECT WARPING MACHINE 598

---

Warping-sizing combination machine 598 is the facility for preparation before weaving. It has both advantages of sectional warping machine and sizing machine, which makes warping and sizing completed once, and directly accomplish the production of beam. It has advantages of low percentage of yarn coverage, good integrity of chorion, quick replacement of the older generation products by new ones, high efficiency, good quality, saving raw materials as well as supplemental materials, reducing production cost.    

• The traverse of warping operation panel is accurately controlled by servo motor.The staring point setting and stripe setting can be achieved automatically once by pressing the button.
• The forward and back movement of warping operation panel is controlled by a step motor,so that the distance between space reed and yarn on drum is consultant and the distance is optional.
• To keep the yarn on the drum can gain constant speed when winding and unreeling,the new technology,AC frequency converter speed adjustment device,which controlled by computer to realize the sleepless monitor,is put into practice.
• The machine is braked by an electronic-mechanical-hydro-pneumatic device during warping.the beaming tension control adopted extemal steel strip damping,which eliminates the noise and uneven tension problems occured in the traditional clamping type damping.
• The optional automatic power control system can be equipped according to the requirements.

Technical Features:

• Working width: 1800-4500(as youe requirements)
• Drum diameter:1026mm
• Cone angle: 9°(1:6.3)
• Cone length:1010mm (for beam flangeφ800mm)
• Outer warp jitter: ≤0.10mm
• Dynamic balance: accord with GB9239 standard 6.3 grade
• Speed:0~150m/min
• Warping operation table traversing  servo motor:1.5kw Delta
• Warping motor: 3kw
• Section traverse speed: 0.001~9.999mm/r
• Traverse deviation: ±0.01mm
• Stripe&start point location:automatic
• Section width: 0-400mm(it can be customized.)
• Drum brake:4pcs clamp brake
• Brake distance : ≤3m (when speed is 80m/min)
• Beaming tension control: pneumatic regulate damping  
• Display: 10.4inch colorful touch screen Delta 

Beaming/Warping Machine:

•  Type: whole beaming machine
•  Motor:18.5KW three phase asynchronous motor 
•  Beaming speed: 0~100m/min
•  Beaming tension: 0~8000N
•  Speed deviation: ≤±1m
•  Beam brake: pneumatic, steel tape brake
• Loading&doffing beam: pneumatic, air valve
•  Beaming safety: safety bar